Use this Clamp Sensor to extend the AC and DC current range of almost any digital multimeter without breaking the circuit under test. Using the KEW8115 with a KEW1051/1052 (DMM) the display can be set for direct reading in A.
Use this Clamp Sensor to extend the AC and DC current range of almost any digital multimeter without breaking the circuit under test. Using the KEW8115 with a KEW1051/1052 (DMM) the display can be set for direct reading in A.
| Measuring Range | AC: 0.1 to 130Arms (185Apeak) | DC: 0 to ±180A |
| Output Voltage | AC: 10mV/A | DC: 10mV/A |
| Accuracy | ±1.2%rdg±0.4mV (50/60Hz) ±2.5%rdg±0.4mV (40 to 1kHz) |
±1.2%rdg±0.4mV |
| Low Battery Warning | 2.2V±0.2V or less - Red LED flash (1.9V±0.2V - Automatically power off) |
|
| Conductor Size | Max. Φ12mm | |
| Withstand Voltage | 3540V AC (RMS 50/60Hz) for 5 sec. | |
| Operating Temperature & Humidity Range |
-10 to 55°C, relative humidity 85% or less (no condensation) | |
| Output Impedance | Approx. 10Ω or less | |
| Applicable Standards | IEC 61010-1 CAT III 300V Pollution degree 2 IEC 61010-2-032, IEC 61326-1 |
|
| Power Source | 3V DC (size AAA alkaline battery LR03x2pcs) Continuous use: approx. 40 hours (Auto power off: approx. 20 minutes) |
|
| Cord Length | Approx. 1,200mm | |
| Output Connector | Φ4mm banana plug | |
| Dimensions | 127(L)x42(W)x22(D) mm | |
| Weight | Approx. 140g | |
